![]() the gearbox output shaft with grease to avoid Torque tighten the battery cover mounting bolts the suspended mounting nut on the rubber pad the gearbox suspended mounting bolts (6.2 the engine tie-bar bolts on the sub-frame (10.5 ![]() the anti-roll bar ball joint nut (4.4 daNm), - the side panel mounting bolts (2.1 daNm), - the gearbox edge and starter bolts (4.4 daNm), - the engine tie-bar bolts on the engine (10.5 ![]() the wheel bolts (13 daNm), - the driveshaft nut (28 daNm), - the lower ball joint nut (6.2 daNm), - the track rod end nut (3.7 daNm), 604-01 Hub locking toolĬheck that the engine-gearbox centring rings are in the plenum chamber partition mounting bolt (2). the two air filter access panel mounting bolts (1), Remove the cowl grille ( Wiping / WashingSection). Disconnect the battery, starting with the negative
0 Comments
Leave a Reply. |